DRAFT
Page: 7
•
Fit the trunking (the following steps describe how to mark up and drill the trunking so
that it
can be fitted over the top of the supply pipes and isolation valves):
o
Position the trunking in front of the hot and cold water outlets and with its end
resting on the floor
o
Remove and retain the
trunking
cap
o
Mark on the back of the trunking the top of the isolation valves and the bottom
of the
supply pipes
o
Use these marks to m
ake a hole large enough for the pipes and isolation valves
to
pass through
o
Remove the backing paper from the self adhesive tape on the trunking
o
Place the trunking over the pipes and isolation valves but do not allow the tape
to
stick to the wall yet
o
Using a level, ensure the trunking is vertical
o
Press the self adhesive tape against the wall to secure the trunking
•
With assistance, place the rise and fall unit onto the wall ensuring that:
o
the two short rails welded to the unit engage with the one on the wall
(see Fig
6
below)
o
the recess in the underside of the rise and fall unit passes over the trunking
(see
Fig 7
below)
•
Ensure that the unit is level, then mark the wall through the
three
attachment points,
one
on
the upper and
two on the
lower horizontal beams
(see
Fig 8
, below)
•
Remove the unit from the wall and at each of the
three
marked positions drill a 6mm
full-
depth pilot hole
•
Open the
se three
holes to accept
appropriate
fixings
•
Fit the fixings into the wall
•
With assistance, place the rise and fall unit back onto the wall-mounted rail,
ensuring
it
is
correct
ly
align
ed
as before
•
Fully
secure
the rise and fall unit to the wall
at the three prepared fixing points
•
Ensure the previously installed mains supply to the junction box on the wall is
switched
OFF
•
Electrically connect the rise and fall unit to the fused outlet using the unit's
three-core
cable. Ensure there is sufficient slack in the cable to allow the unit
to rise and fall
•
Fit the handset BEFORE switching the power on
•
Secure the handset to the cable tie mount
(see diagram on next page
for
location of cable tie mount)
using the cable tie supplied
(see fig 10, p.9)
•
Switch on the mains voltage
Check that
the
Obstacle sensing sw
itch on the arms works properly:
•
Operate the lowering function and then lift the right hand arm
on the unit
to ensure
th
at the unit stops travelling downwards
•
Leave the mains voltage supply switched on
Electrical connection:
Fig
6
Fig
7
Fig
8
Version
4
:
2
5
-0
9
-01
9
