22
Three parameters must be set in this panel:
The output to be affected by the photocell (selectable from A, B, C, AB, AC, BC or ABC).
Analysis time before switch-on – this is the time before astronomical output switch-on, in which the driver
analyses the status of the input. For example, assuming that Astro switch-on time on a given day until 16:40:00
and the photocell is analyzed 15 minutes before switch-on, it means that the signal will appear at the driver
input from the photocell in the range from 16:25:00 to 16:40:00 and it will accelerate the activation of a
selected output.
Analysis time before switch-off – this is the time before astronomical output switch-off, in which the driver
analyses the status of the input. For example, assuming that Astro switch-off time on a given day is 04:40:00
and the photocell is analyzed 20 minutes before switch-off, it means that the loss of the photocell signal from
04:20:00 to 04:40:00 will accelerate the switch-off of a selected output.
After all parameters have been entered, press the "Set" button to confirm the changes.
5.7.2
Cascade configuration
In case of selecting the input mode as "Cascade", the next step should be to set the rules of influence of the input state
on the output state. In order to configure the cascade, press one of the cascade parameters from the "Input 1" screen
to open the dialog window as shown below.
