16
OFF – the output is permanently switched off and not subject to any control rule.
ON – the output is permanently switched on and not subject to any control rule.
It is switched on for a specified time, after which it switches to the AUTO status.
The output mode can be changed on the "Service connections" screen or on the "START" screen, if you have selected
a simplified view of the panel, see figure below.
A single pressing of the ON button will activate the output for 1 minute, double pressing will activate the output for
10 minutes, triple pressing will activate the output for 30 minutes, after that time the output will enter the AUTO
mode, while a quadruple pressing of the ON button will activate the output permanently and will not be subject to
any control rule.
Pressing the OFF button will switch off the output permanently.
For factory settings, outputs A and B operate in AUTO mode.
5.6.1
Day operation mode (lighting day / 24-hour day)
The ASTmidi / ASTmidi GPS driver can operate according to the 24-hour day (from 00:00:00 to 00:00:00:00) or the
lighting day (from 12:00:00 to 12:00:00:00). In order to change the type of day, select the day parameter on the
"START" screen, which will display a dialog box enabling the selection of the day, and a message informing that the
change of day will restore the switching intervals for the outputs A, B and C to their default values. In the case of a 24-
hour change from 00:00 to 00:00:00, the switch-on periods will be reset, i.e. the outputs will not be subject to any
control rule; in the case of a 24-hour change from 12:00 to 12:00, the intervals will be set. T1 start: Astro and T1 stop:
Astro, i.e. the outputs will be switched on at sunset and switched off at s- time adjustment, see figure below.
