25
A: Oil mirror place
B: put oil place
C: filling hole
Take out Oil:
Open the chassis cover.
Put the tank or tray in bottom of “B”
Take the oil drain plug with the proper size wrench.
Put out oil
After take out oil, put the drain plug back.
Used oil should be handled in accordance with environmental regulations.
Note: When you unscrew the oil drain plug, the oil flows out through the drain hole
(below must put a oil pan).
After the oil is done and, if possible, the vacuum pump is inclined slightly exhausted all
residual oil.
Fill oil:
Be careful! Damage to the machine!
The correct type of oil and oil volume is very important for the vacuum pump.
Using the wrong vacuum pump oil or adding too much oil will damage the pump.
New machine must fill oil.
when the oil level low or take out old oil need to fill the oil
Must use the correct size wrench to remove the filler plug.
Injected about the right amount of the right pump for oil, vacuum pump oil, refer
to specific "dedicated vacuum pump oil" section.
Ensure that the oil level in the oil level between 1/2 to 3/4 of the mirror.
Make sure the filler plug is installed in the ring and in good condition, be sure to
replace if necessary.
spin good filler plug.
Wait a few minutes.
Check the oil level in the oil level between 1/2 to 3/4 of the mirror, if the oil level is