13
An ASSA ABLOY Group brand
P/N AYRT-210-INST-FUL Rev E
21. Insert four (4) AA alkaline batteries; the lock
will respond with flashes and beeps.
22. Install battery cover and tighten Phillips
head screw.
Install Batteries
Figure 22
CW
Figure 24
Figure 23
CCW
Install the Interior Lever
NOTE
: Hex set screw should be inserted
enough for lever handle to slide over
shank, clearing set screw.
18. Install hex set screw.
A. Place set screw in hole on side of
shank toward latch (Fig. 22); turn set
screw CW to allow for placement of lever
handle over shank.
Do not overtighten.
A. Remove hex key.
19. Place interior lever handle over shank
until hole on handle aligns with set screw
in shank.
20. Secure lever handle by inserting hex key and
rotating set screw
CCW
(Fig. 23).
This will retract the set screw back into the
lever handle to secure it in place.
Do not overtighten.
NOTE
: Thumbturn should still be in horizontal position.
IMPORTANT:
Before installing the batteries,
test the lock's mechanical operation. Place
the thumbturn in the
horizontal
position. Lift up and push down on both the interior and
exterior levers (one at a time) to verify that the latch is retracted by both levers in the un-
locked position.
Next place thumbturn in the
vertical
position. Lifting up or pushing down on the exterior
lever should
not
retract the latch. Lifting up and pushing down on the
interior
lever should
still retract the latch in the locked position .
Finally, insert key in cylinder and rotate clockwise until thumbturn moves to horizontal
(unlocked) position.
If operation is not smooth for any of these procedures, review the previous steps to ensure
proper installation, while maintaining proper alignment of escutcheons.
