Spindle Slot
1/4"
Approx
Sleeve Hole
Knob Collar
Cylinder
Knob
Knob Catch Slot
Cylinder
Tailpiece
Spindle
Knob Catch
(Hidden Under
Sleeve Hole)
9
ATTACH INSIDE ROSE
SNAP ON ROSES: Slip on retainer plate and
fasten with two
(2)
machine screws. Snap rose
over retainer plate, aligning slot and tab.
Tighten Screws
Tab
Slot for Removing Rose
10
REPLACE INSIDE KNOB
Line up slot in shank with knob catch in spindle. Slide
knob onto spindle. Depress knob catch and push knob
into engaged position.
NOTE
Knob button should be
in unlocked position
when replacing
inside knob.
Depress
Knob Catch Align
Slot
1.
To remove knob, follow steps 1-3 of "
To remove cylinder for replacement or rekeying" above
.
2.
Rotate knob 180° (so keyway is vertical and down). Push knob onto spindle until it
contacts
knob catch.
3.
Continue with steps 4-6 of "To reassemble" above.
NOTE
When a cylinder function lock is correctly installed, the key
should enter in this position.
If not, reverse cylinder as follows:
NOTE FOR PRIVACY FUNCTION:
In an emergency, entrance to a locked
door can be gained by inserting a flat
blade screwdriver into slot located in
center of outside button head.
To remove cylinder for replacement or rekeying:
1. Insert key fully into cylinder.
2. Insert small end of knob collar tool into outside knob sleeve hole.
3. Turn key (in clockwise direction) at least 45° or until depression of knob
catch is felt. Pull off knob.
4. Remove knob collar by using tool provided.
5. Remove cylinder for re-key or replacement.
To reassemble:
1.
Insert cylinder into knob.
2.
Replace knob collar on knob and press into place.
3.
Insert key fully into cylinder.
4.
Press
small end of knob collar tool
into outside knob sleeve hole.
5.
Turn key (in clockwise direction) at least 45
°
or until depression of knob catch is felt.
6.
Checking alignment of cylinder head with hole in knob, push knob until knob catch
"clicks" into position.
INSTALLATION FOR DUMMY TRIM
1.
Place chassis on door
with
knob
catch facing edge of
door
. S
ecure with
mounting
screws.
2.
Attach inside rose.
See Section 9.
3.
Replace inside knob. See
Section 10.
Knob Catch
1
2
Knob Catch
Hole
3
EDGE OF DOOR
Knob
Rose Assembly
Mounting
Screw
Spindle
Chassis
CYLINDER REPLACEMENT
AND
REASSEMBLY
Knob Collar Tool
Retainer
Plate
263007770 (0
8
-1
9
)
Product Support Tel 800.438.1951 • www.yalelocks.com
Yale Locks & Hardware is a division of
ASSA ABLOY Access & Egress Hardware Group, Inc.
Copyright © 2016, 2018,
2019
ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
