5
500-17700, Rev D
Mount the Plastic Base to the Door
1. PERFORM the following to mount the plastic base to a
hollow metal
door
.
a. LOCATE the two supplied blind nuts.
b. INSERT the nuts with the knurl engaging the edge of each hole.
c. USE the supplied collapsing tool to collapse the nuts (see
Figure 1, “Collapsing the Blind Nuts in a Metal Door”).
d. PLACE a tooth washer under the head of each screw and
MOUNT the plastic base.
e. TIGHTEN the cap screw, but DO NOT OVERTIGHTEN.
Figure 1. Collapsing the Blind Nuts in a Metal Door
Connect the Electrical Within the Plastic Base
NOTE:
Electrical connections with the plastic base must be made
before the handle is attached to the base.
1. ROUTE the cable connector across the circuit board and PLUG into
the corresponding connector on the board (see Figure 2, “Plastic
Base and Handle Detail”).
