Communicators Menu - SecureWave Panels - contd.
2
IP Address
2
Disable WiFi
2
Fault Delay
2
Monitor Faults
2
WiFi
1
DHCP Enabled
1
Status
Yes
10m
Yes
1
Monitor Signal
1
IP Settings
1
GSM
5
DNS Server
4
Gateway
4
WiFi Network Scan
3
Subnet Mask
3
Options
3
Tamper
This sub-menu disconnects the WiFi path from
.
SecureComm
When you select the
WiFi Network Scan
sub-menu, the
system searches for WiFi signals in your vicinity for you to
choose from.
Monitor Signal
will flag a fault in the event of a WiFi network
failure. By default it is set to YES.
You can delay the notification of a fault by going to the
Fault
Delay
sub-menu and keying-in a delay time in minutes. Useful
in areas of poor WiFi coverage that are prone to occasional
brief dropouts. By default it is set to 10 minutes.
In this sub-menu you can turn off the
Tamper
signal from the
communicator. By default it is on i.e. YES.
9221 WiFi Status
9222 Disable WiFi
9223 Options
9223 Options
92231 IP Settings
92232 Monitor Faults
922321 Monitor Signal
922322 Fault Delay
922323 Tamper
This sub-menu offers an overview of the
SecureComm
connectivity and where you will find the
Installation ID
number.
9224 WiFi N’work Scan
22
DHCP is enabled by default. This is an auto-configuration
protocol used on IP networks. When it is enabled, you do not
have to configure the other four sections i.e. the IP Address,
Subnet Mask, Gateway and DNS Server. We strongly
recommend that you leave the
DHCP Enabled
set to YES
unless you are installing the system on a site where the IT
department may want these configured in a particular way.
