5
BHL Trim
Installation Instructions
8200 Series
A8131F 08/19
Copyright © 2019, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or
in part without the express written permission of SARGENT Manufacturing Company is prohibited.
1-800-727-5477 • www.sargentlock.com
h
For 04, 06, 13 and 31 Functions:
A. Remove green catch screw.
B. Rotate hub to 45° position.
C. Rotate locking piece for required hand.
D. Face red surface to locked side of door.
E. Rotate hub to original 45° position (as shown on lockcase).
F. Reinstall green catch screw.
NOTE:
• Beveled surface of latch must face strike.
• Deadlatch is self adjusting.
To change hand of latch:
1. insert screwdriver blade into the spade
shaped slot.
2. Rotate screwdriver 90° to push latch
out until back of latch
clears lock front. Rotate latch 180°.
Latch will re-enter lockbody.
NOTE:
Spade Shaped Slot
Figure 3
Items needed to create each of the following functions:
Function
Outside
Lever
Inside
Lever
Trim One
Side Kit
Outside
Cylinder
Inside
Cylinder
Thumb
turn
04 (F07) -
Store Room
Closet Lock
X
X
X
05 (F04) -
Office or Entry Lock
X
X
X
X**
06 - Store room or
Service Lock
X
X
X
13 (D31) -
Communicating or
Exit Lock
X
X
31 - Utility Lock
X
X
X
36 - Closet Lock
X
X
X
37 (F05) -
Classroom Lock
X
X
X
38 (F32) -
Classroom Security
Intruder Latchbolt
Lock
X
X
X
X
#41 Cylinder is standard for both single & double cylinder functions for 1-3/4” thick door.
** 130 KB thumb turn is used with rose trim only. Escutcheon trims requiring thumb turns must be
preassembled at factory.
NOTE:
Trim-one-side functions always require an inside trim assembly which can be used on the inside or
outside of the door (to order Trim one-side kit (for all trim except PT or FE) order part # 82-4611.
