4
ED8200A Series
Installation Instructions
Fire-Rated Rim Exit Device
FM124B 04/20
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Copyright © 2011, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
c
Cut Pushbar (If Required)
Note
If bar does not require cutting, proceed to step 4a.
A. Installation of device depends on trim: Note 3/4" (19 mm) minimum restriction. (Figure 3)
B. Measure and mark bar as shown. (Figure 4)
C. Fully depress bar and cut off square on mark. (Figure 5)
Figure 3
Figure 4
3/4" (19 mm) Min.
Cut off point
Door width minus
5" (127 mm)
Pushbar
must
be fully
depressed
Figure 5
