1 6
1 6
1 6
1 6
1 6
Primary IDE Connector (Blue)
Secondary IDE Connector (Black)
(39-pin IDE1, see p.9, No. 8)
(39-pin IDE2, see p.9, No. 9)
Note: If you use only one IDE device on this motherboard, please set the IDE
device as “Master”. Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
Serial ATA Connectors
These four Serial ATA (SATA)
(SATA1: see p.9 No. 16)
connectors support SATA data
(SATA2: see p.9 No. 15)
cables for internal storage
(SATA3: see p.9 No. 14)
devices. The current SATA
(SATA4: see p.9 No. 13)
interface allows up to 1.5 Gb/s
data transfer rate.
Serial ATA (SATA)
Either end of the SATA data cable
Data Cable
can be connected to the SATA
hard disk or the SATA connector
on the motherboard.
Serial ATA (SATA)
Please connect the black end of
Power Cable
SATA power cable to the power
(Optional)
connector on each drive. Then
connect the white end of SATA
power cable to the power
connector of the power supply.
SA
T
A
1
SA
T
A
2
SA
T
A
3
SA
T
A
4
IDE1
PIN1
IDE2
PIN1
connect the black end
to the IDE devices
connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
connect to the
power supply
connect to the SATA HDD
power connector
VGA_2x8 Cable
Please connect either end of
VGA_2X8 cable to J1 jumper of
VGA_HDTV panel and the other
end to VGA1 header of this
motherboard.
AV/S_2x3 Cable
Please connect either end of
AV/S_2x3 cable to J2 jumper of
VGA_HDTV panel and the other
end to TV-OUT header of this
motherboard.
