3 0
3 0
3 0
3 0
3 0
OnBoard IDE Controller
You may enable either the primary IDE channel or the secondary IDE channel.
Or you may enable both the primary and the secondary IDE channels by
selecting [Both]. Set to [Disabled] will disable the both. Configuration options:
[Disabled], [Primary], [Secondary], [Both].
OnBoard SATA Controller
Use this item to enable or disable the “OnBoard SATA Controller” feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this
option is [RAID]. If you don’t want to operate RAID function on SATA HDDs,
please select [non-RAID]. However, if you want to install Windows 98 SE
/ ME without RAID functions, please still select [RAID].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the “Primary IDE Master” as the example in the following instruction,
which can be applied to the configurations of “Primary IDE Slave”, “Sec-
ondary IDE Master”, and “Secondary IDE Slave” as well.
However, if you plug PCIE-SATA2 card to this motherboard, the IDE Configura-
tion screen will be as below.
PCIE-SATA2 Operation Mode
This option will appear if you plug PCIE-SATA2 card to this motherborad.
Use this item to adjust PCIE-SATA2 Operation Mode. The default value of
this option is [IDE]. Configuration options: [IDE], and [SATA].
BI
O
S SETUP UTI
L
IT
Y
IDE Configuration
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Ad
v
a
nc
ed
OnBoard IDE Controller
OnBoard SATA Controller
SATA Operation Mode
PCIE-SATA2 Operation Mode
Primary IDE Master
Primary IDE Slave
Secondary IDE Master
Secondary IDE Slave
SATA1
SATA2
PCIE-SATA2 Card
[Both]
[Enabled]
[RAID]
[IDE]
[Hard Disk]
[Not Detected]
[ATAPI CDROM]
[Not Detected]
[Not Detected]
[Not Detected]
[Not Detected]
Select Screen
Select Item
+-
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
Select Screen
Select Item
+-
Change Option
F1
General Help
F9
Load Defaults
F10
Save and Exit
ESC
Exit
DISABLED: disables the
integrated IDE
Controller.
PRIMARY: enables only
the Primary IDE
Controller.
SECONDARY: enables
only the Secondary IDE
Controller.
BOTH: enables both IDE
Controllers.
