Aspirante ASP2000THM, Инструкция по установке и эксплуатации

Страница: 12 / 29

Aspirante thermostatic power shower
0
FITTING THE SHOWEr TO THE WALL
Important: Prior to fitting the shower,
make sure that the plumbing is flushed out,
removing all debris, flux, etc.
For top pipe entry or top cable entry, remove
the relevant cut-outs by either breaking out or
by using a knife or junior hack saw
(fig.) .
If top entry for both pipe and cable is required,
then additionally remove the shaded area
(fig.) by using a knife or junior hacksaw.
For bottom pipe entry, remove the cut-out and
break off the two circular parts
(fig.) . Replace
the cut-out.
For rear pipe entry only, the supplied elbows
must be used with the necessary portion of
backplate cut away as shown in
fig.9 .
If rear cable entry is required, conduit or
other routing of the electrical cable must be
completed before fixing the shower to the wall.
Offer the backplate unit up to the completed
pipework and manoeuvre so that the end of the
pipes enter fully into the inlet fittings.
Mark positions for wall fixing holes using
backplate as template
(fig.) . note that four
fixing holes are provided but using only two
should be adequate for most site conditions.
using the pipe removal tool supplied, push back
and hold the collets from the pipework
(fig.)
in order to disengage pipework from the inlet
elbows.
Remove unit from the wall.
Important: before fitting the shower
to the wall check that the safety earth
contact spring has not been damaged. If
the spring has been damaged then Do NoT
fit the shower and return the appliance for
replacement.
Drill and plug the wall.
(An appropriate drill bit should be used. If the
wall is brick, plasterboard or a soft building block,
appropriate wall plugs and screws should be fitted).
Remove shaded area
Cut out
for cable
3
Fig.
Fig.
Fig.