aspenhome
R
ASSEMBLY INSTRUCTIONS
MADE IN VIETNAM
ah
Page 5/6
STEP 3: Screw the bolts(E) into HB & FB. Align the bolts with the holes in the end of side rails
and attach the side rails to HB & FB using half moon washer(F),and hex nuts (G).Then use a hex
wrench to tighten all the nuts.
Headboard
Side Rail
E
The outside holes match to 6/6 standard king rails,
the inside holes match to 6/0 Cal king bed rails.
F
G H
Slat bearer
I218-407
I218-425
I218-406
I218-410
Support Leg
Leveler
This End Up
Slat
STEP 4: Remove the support legs (top)
as shown in the picture
to the right
. Attach the support legs with leveler to the slats.
Adjust the levelers on bottom of support legs when necessary.
Remove
Support Leg(top)
I
ITEM NO:
I218-425-WHT/SHL King Uph HB
I218-407-WHT/SHL King Low Profile FB
I218-406-WHT/SHL King Rails w/ Decking
I218-410-WHT/SHL Cal King Rails w/ Decking
01-02-2020
STEP 5: Arrange slats on the slat bearers and then lay the decking on top of the slats. Make sure
the top and bottom slats are situated underneath the pre-drilled holes as shown below in STEP 6.
Remove the decking and attach slats to the slat bearers with wood screws (I).
