EFD1000 E5 Dual Electronic Flight Instrument (EFI) Install Manual
DOCUMENT # 900-00041-001
PAGE 222-226
REVISION D
© Copyright 2019 Aspen Avionics Inc.
Positive numbers are Roll right and Pitch Up. Negative numbers are Roll left and Pitch down.
a)
Generate a +5º right bank – verify the yoke moves counter-clockwise or left.
b)
Generate a -5º left bank – verify the yoke moves clockwise or right.
c)
Generate a +5º pitch up – verify the yoke moves forward.
d)
Generate a -5º pitch down – verify the yoke moves back.
CAUTION: If the yoke moves the wrong direction then inspect the TR box for a wiring error. If it is
wired per the drawing but still the pitch or roll is backwards then it is acceptable to reverse the wires
inside the TR box at pins 8 & 9 for pitch or pins 10 & 11 for roll.
E5.9 Autopilot Gyro Alignment
See Tech Note 2010-10 for instructions on using the EA100 Alignment Tool and the autopilot
manufacturer’s alignment procedure to make these adjustments.
Bendix King Autopilots
Align the EA100 Adapter to the autopilot computer using a KTS-150 Test Set, a KTS-158 Test Set, a
KTS-154 Test Set or other appropriate autopilot test set, and following the autopilot manufacturer’s
procedure for aligning the gyro to the autopilot computer. The EA100 Alignment Tool will be used to
manipulate the gyro pitch and roll signals and the autopilot Test Set or break out box will be used to
measure the autopilot gyro voltages. In the case of the KFC225 the Remote Terminal Interface will be
required in place of the test sets.
Century Autopilots
Set the Roll Bank limits in flight per the Century Flight Systems instructions.
E5.10 Ground EMI Test
NOTE
The appropriate autopilot test equipment and certifications will be required for this work.