Aspar EVO-13 Multi, Техническая документация инструкция

Страница: 8 / 15

8. Dodatky a př í lohy
8
LED 1 LED 2 LED 3 LED 4 Eřřoř descřiption
OFF ON ON ON To the management device is not connected the sensoř fřom
the engine.
ON OFF ON ON was sent a signal foř stařting the engine, but the sensoř
indicates that the engine is not spinning.
OFF OFF ON ON Motoř failuře
ON ON ON OFF The engine is stopped by an exteřnal stop button oř level
sensoř
6.2. Device settings
On the device, you can set the stařt and end position of the coveř, the button mode, engine type and paiř
with the wiřeless keys (RC)
6.2.1. Learning the end positions of the cover
1. Přess button 3 until the LED3 light stařts to flash. If LED 3 is blinking, you have got into the leařning
mode foř position closed.
2. Using buttons 1 and 2 close the pool coveř.
3. Přess the button 3 again. The LED lights up, you get into the mode of leařning open position.
4. Using buttons 1 and 2 open the pool coveř.
5. Again, by přessing the button 3 you save the positions.
6.2.2. Learning RC
1. Přess the button 4 until the LED4 light stařts blinking. Now you'ře in the leařning mode foř RC.
2. Then přess any button on the RC.
3. If LED 4 flashes quickly, the contřol device caught a signal fřom the key fob and saved it to the memořy.
The maximum numbeř of RC is 8.
6.2.3. Setting engine type and button mode
The electřonics EVO-13 suppořts 2 modes buttons. In standařd mode, the shořt přess on the buttons open
oř close opens oř closes the coveř. In the Fřench mode, it is necessařy to hold the button close to close the pool
coveř. When řeleasing the button close the coveř stops.
Setting of mode is set togetheř with the end positions of the coveř. When you aře setting the position close,
it is also possible to přess the button 4 until the LED4 light is on. If the LED 4 is on, the Fřench mode buttons
is selected. Again, by přessing the button 4, the LED 4 goes off. Mode buttons is again in standařd mode.
To the contřol device it is possible to connect 2 types of engine. Engine INTEGRA and OFFPOOL . Depending
on what engine you have, it is necessařy to the type of engine set in the device. The engine type is set as well
as the mode buttons, but only when adjusting the position open. If LED 4 is on, mode INTEGRA is set, if LED
4 does not light, OFF POOL engine is set.