SlimScan BT Full Manual
7
Charging the batteries
First, make sure that the plug pack power supply is connected to the
cradle cable box, and plugged into the mains.
Then, place the scanner into the cradle as shown below, and press down
until the scanner clicks into place.
The scanner will sound a short beep after a few seconds when it’s
correctly seated in the cradle.
To start charging, press either of the small buttons at the side of LED
indicator on the base (as shown below). The red LED on the scanner
will light to show that it is being charged.
Why doesn’t the scanner charge automatically?
Battery life depends on the number of times the batteries are charged,
so we recommend charging the batteries only when they need it, rather
than every time the scanner is placed in the cradle.
If you’d rather automatically charge the batteries every time the scanner
is placed into the cradle, you’ll find barcodes to configure the scanner
that way in the programming section of this manual.
Note: you should charge the batteries for at least six hours before using
the scanner for the first time.
The scanner should run for at least eight hours continuously per charge.
Press down firmly here
Содержание SlimScan BT
Страница 2: ......
