19
309423
Displacement Pump Replacement
Removal
1.
Flush pump (13).
2.
Relieve pressure
;
page 4.
3.
Fig. 10. Loosen two screws (10b) and rotate
cover (10a).
Fig. 10
10a
10b
9a
9573A
4.
Cycle pump until pump pin (9a) is in position to be
removed. Remove pump pin (9a).
5.
Fig. 11. Remove suction tube (78) and hose (19).
6.
Loosen pump jam nut (12). Unscrew pump.
TI1647A
T
Fig. 11
78
12
19
Installation
WARNING
If pin works loose, parts could break off due to
force of pumping action. Parts could project
through the air and result in serious injury or prop-
erty damage.
CAUTION
If the pump locknut loosens during operation, the
threads of the drive housing will be damaged.
1.
Fig. 12. Extend pump piston rod fully. Apply grease
to top of pump rod at (A) or inside connecting rod.
Fig. 12
A
TI0062
2.
Fig. 10. Install pump pin (9a). Verify retainer spring
(9b) is in groove of pump pin.
3.
Push pump up until pump threads engage.
4.
Screw in pump until threads are flush with drive
housing opening. Align pump outlet to back.
5.
Fig. 11. Install suction tube (78) and hose (19).
6.
Fig. 13. Screw jam nut (12) up onto pump until nut
stops. Tighten jam nut by hand, then tap 1/8 to 1/4
turn with a 20 oz (maximum) hammer to approxi-
mately 75 +/–5 ft–lb (102 N
m).
Fig. 13
TI0063
7.
Fig. 14. Fill packing nut with ASM Packing Seal
until fluid flows onto top of seal.
TI0061
Fig. 14
10a
10b
8.
Fig. 10. rotate cover (10a); tighten screws (10b).
Содержание Zip-Spray 233782
Страница 27: ...27 309423 Notes ...
