9
309508
General Repair Information
Pressure Relief Procedure
System pressure must be manually relieved to prevent
system from starting or spraying accidentally. Fluid
under high pressure can be injected through skin and
cause serious injury. To reduce risk of injury from
injection, splashing fluid, or moving parts, follow
Pres-
sure Relief Procedure
whenever you:
1. Lock gun safety latch.
2. Turn ON/OFF switch to OFF.
3. Unplug power supply cord.
4.
Unlock gun safety latch. Hold metal part of gun
firmly to grounded metal pail. Trigger gun to relieve
pressure.
5. Lock gun safety latch.
6. Open pressure drain valve. Leave pressure drain
valve open until ready to spray again.
If suspected that spray tip or hose is completely
clogged, or that pressure has not been fully relieved
after following steps above
, VERY SLOWLY loosen tip
guard retaining nut or hose end coupling to relieve
pressure gradually, then loosen completely. Now clear
tip or hose obstruction.
CAUTION
To reduce risk of pressure control malfunction:
Use needle nose pliers to disconnect wire. Never
pull on wire, pull on connector.
Mate wire connectors properly. Center flat blade of
insulated male connector in female connector.
Route wires carefully to avoid interference with
other connections of pressure control. Do not pinch
wires between cover and control box.
1.
Keep all screws, nuts, washers, gaskets, and
electrical fittings
removed during repair proce-
dures. These parts are not normally provided with
replacement assemblies.
To reduce risk of serious injury, including electric shock,
do not touch moving or electrical parts with fingers or
tools while testing repair. Shut off and unplug sprayer
when inspection is complete. Install all covers, gaskets,
screws and washers before operating sprayer.
2.
Test repair
after problem is corrected.
3.
If sprayer does not operate properly
, review
repair procedure to verify procedure was done
correctly. If necessary, see Troubleshooting Guide,
pages 10 – 14, for other possible solutions.
Motor and drive housing may be very hot during opera-
tion and could burn skin if touched.
Flammable materials spilled on hot, bare motor could
cause fire or explosion. Have motor shroud in place
during operation to reduce risk of burns, fire or explo-
sion.
CAUTION
Do not run sprayer dry for more than 30 seconds to
avoid damaging pump packings.
4.
Install motor shroud before operation
of spray-
er and replace if damaged. Motor shroud prevents
overheating, and protects operator from possible
electrical shock by touching terminals of capacitor.
It can also reduce risk of burns, fire or explosion;
see preceding
WARNING
.
Содержание 249166
Страница 23: ...23 309508 Notes ...