Components and measured values
WASHING MACHINE MOTOR
WM 50/55A/56/66A (FHP)
Art.no.
80 637 34 (50/60 Hz)
Resistances:
Pins 5-6
Stator
1,58 W
Pins 7-6
Stator
0,87 W
Pins 3-4
Rotor 1,20 W*
Pins 1-2
Tacho 135 W
*) 1,20 W measured diagonally across collector.
All resistance values are ±8%.
MOTOR CONTROL UNIT
WM 50/55A/56/66A
Art.no.
80 613 99
The motor control unit is an external unit
(MCU) which is installed on the bottom and
connected to the program control card (PCU),
see electrical diagram.
ELEMENT
2000 W
Art.no.
80 617 06
Resistance:
28,4 W
1000 W
Art.no.
80 617 07
(Certain models)
Resistance:
56,7 W
THERMISTOR
Art.no.
80 616 63
Resistance:
65-35 kW
Room temperature 20-30 °C
The thermistor for temperature measurement is
installed between the motor cradle and the
tank.
The thermistor measures and controls the water
temperature, which may vary from 0-90 °C.
The element is sisconnected if the thermistor is
short- circuited or disconnected from the
program control card or programmer.
DRAIN PUMP
50 Hz
Art.no.
80 616 96
N.B. Ordered under art.no. 88 011 66.
Resistance: 144 W
Current: 0,2 A, 23 W loaded
60 Hz
Art no.
80 619 37
N.B. Ordered under art.no. 88 011 67.
Resistance: 76 W
Current: 0,3 A, 28 W loaded
The drain pump is combined with an integra-
ted needle trap, which can be cleaned by the
user.
If the drain pump has run for 180 seconds during
draining, the program i stopped, reset and an error
code appears on the display.
RINSE SENSOR, RPS
(WM66A)
Art.no.
80 628 16
ASKO Rinse sensor type 6622.
The rinse sensor is installed next to the drain
pump and controls the turbidity of the outgo-
ing rinsing water. The sensor is connected to the
PCU, see electrical diagram.
LEVEL SWITCH
Art.no.
80 642 75
An electromechanical level switch with two
levels, see wiring diagram. Controls the water
level and starts the drain pump if Over flow is
indicated.
