Asko DBI664 XXL, Руководство по эксплуатации

Страница: 16 / 24

Troubleshooting
Action Type of fault on the display
Clear the drain pump. See the section Care and maintenance instructions. If the problem persists,
call the Customer Care Center.
Overfilling water 1 F10
See “Water remains in the dishwasher above the filters” in the table “Problem” below. If the problem
persists, call the Customer Care Center.
Water outlet fault F11
Check that the water supply valve is on. If the problem persists, call the Customer Care Center. Water inlet fault F12
The water pressure should be 4.2-140 psi.
Turn off the water supply valve and call the Customer Care Center. Inlet valve leakage F40
Call the Customer Care Center. Water level fault F52
Turn off the water supply valve and call the Customer Care Center. Overfilling water 2 F54
Call the Customer Care Center. Circ. pump fault F56
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons too soon after
opening the door.
The buttons do not react when pressed.
See the chapter Settings. Child lock (button lock) activated.
Open the door. The buttons only react to use
when the door is open.
The door is closed.
Clean with a dry or slightly damp cloth. The buttons are dirty.
Check that the baskets are correctly positioned
horizontally.
The baskets are not correctly positioned. Cannot close door.
Check that the dishes are not blocking the
baskets from sliding properly into place.
Press and hold Start/Stop until the display shows
"Program started, close door in 4 sec".
The Start/Stop start button has been pressed for
too short a time.
The dishwasher does not start.
Close the door within four seconds, otherwise
the dishwasher will not start.
The door is not closed properly or was not closed
immediately after pressing the Start/Stop button.
Check. A fuse/circuit breaker has been tripped.
Check. The plug is not plugged into the power outlet.
Check. The water supply valve is turned off.
Check. Overflow/leaks.
Turn off the water supply valve. Pull out the plug
and call the Customer Care Center.
A whirring sound (the drain pump) is heard from
the dishwasher and does not stop when the main
power switch is turned off.
Press and hold Start/Stop for three seconds if
you want to cancel the Delayed Start option.
Check that the Delayed Start option has not been
selected.
16