Page 9
Now that all the connections are made and the machine
is in place under the cabinet, you should make the final
height adjustment.
1. You should set the
rear foot first. To do
this, use a
screwdriver to rotate
the adjusting screw
on the bottom front of
the machine. Turn the
screw clockwise to
raise the foot and
anticlockwise to lower it.
NOTE:
When adjusting the unit lower than 33-1/4” (845
mm), the holes on the toe kick will need to be
elongated. An accessory toe kick is also
available for this type of installation. Contact
your dealer to order.
2. Using a 1/2” (12 mm) wrench, adjust the locking
nuts until the machine is
level. (The machine may
have an inclination of 2°
maximum without affecting
its performance.)
3. When the feet are properly adjusted, tighten the
locking nuts to the base pan.
ADJUSTING THE TOE KICK
HEIGHT ON D3250FI AND D3530FI
These models come with a European kickplate.
Once you have the toe kick bracket in place, you can
install the toe kick, as follows:
1.
If you have not done so, take the toe kick and felt
insulation from the top of the machine-packaging.
2.
Lay the insulation on the back side of the toe kick to
make sure it fits properly.
3.
Peel the adhesive protection strip off the insulation
and press it firmly to the back side of the toe kick,
making sure you don’t cover any slots on the toe
kick.
4.
Positioning the notches on the toe kick at the edge
of the access panel, slide the toe kick up behind
the access panel then let it slide to the floor.
5.
Screw the toe kick to the toe kick brackets.
6.
Adjust the toe kick depth.
INSTALLING THE TOE KICK
It’s necessary to fasten the dishwasher to the cabinet
so it won’t tilt when the door is opened or if something
heavy is placed on the door. Use only the stainless
steel screws provided with the machine.
1.
Use option A for U.S. or European standard
installations. Use option B only for European
standard installations.
2.
Cover the screw heads with the
plastic plugs provided with the
machine.
3.
When the machine is properly
attached, check that the feet are
tight against the floor and that the
machine is level.
FASTENING THE DISHWASHER TO THE CABINET
NOTE:
When it is not possible to attach the dishwasher
to the cabinet, you should install tip guards.
(See “Tip Guards” on page 2.)
Option A can be used for U.S. or European
installations. Use option B for European
standard installations only.
NOTE:
Mounting
Screws
ADJUSTING THE LEVELING LEGS
SETTING THE TOE KICK
DEPTH
1.
Press the grey catches
toward each other to
release the bracket.
2.
Pull out the holders as
far as required.
3.
Press in the catches so
that they lock the
brackets in place.
2.
Hang the kick-plate onto the holders by inserting it
into the grooves.
