Page 2
TOOLS
1)
Phillips No. 2 screwdriver
2)
Flat blade screwdriver
3)
Torx screwdriver size T 20
4)
Adjustable wrenches (if you use copper fittings)
5)
Open-ended wrench (1/2" [12 mm] or 5/8" [16 mm])
6)
Tape measure
7)
Spirit level
8)
Electric drill with 1” drill bit
9)
Keyhole saw
MATERIALS
♦
Minimum 3/8" OD copper tubing of sufficient length
for your installation
♦
Shut-off valve and fittings for water supply line
Tip Guards (optional)
When it is not possible to attach the
dishwasher to the cabinet or the
underside of the cabinet top, you
should install tip guards to prevent the
machine from tipping when you open
the door.
Refer to page 4 for installation
instructions.
TECHNICAL DATA
Water pressure
18-176 psi
Power
120 V, 60 Hz, 15 amp.
Heating element
1200 W
Max loading
1300 W
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
If a dishwasher is being installed in this area for the
first time, most of the cabinet work, plumbing, and
electrical has to be done before you move the machine
into place.
NOTE: Cosmetic damage must be reported to the
ASKO dealer within five days from the date of purchase.
As soon as you unpack the dishwasher, thoroughly
check it for cosmetic damage.
If you are replacing an old dishwasher, you must check
the plumbing connection and wiring before you move
the new dishwasher into place.
Tip Guards
(P/N 8070851)
INTRODUCTION
WHAT YOU NEED
The dishwasher is shipped with the high loop drain
hose, inlet hose and electrical cord attached and ready
to be connected.
