4
ASSEMBLY
ASSEMBLY INSTRUCTIONS
This appliance is offered in three different con
fi
gurations of which you get to choose. You have the option to install your new heater
as a freestanding heater on a pedestal,on legs or as a
fi
replace insert.
You must purchase the desired kit separately from your
appliance dealer.
Read and follow the directions in this manual and inside the chosen kit to ensure proper assembly, installation
and operation of your new wood heater.
While installing the desired kit you must install the primary air damper. The damper is shipped in place. Simply secure the damper
limit screw through the damper’s slot and into the pre-threaded hole.
Caution! The appliance is very heavy.
The assistance from a second person is strongly suggested. Please use proper lifting technic when positioning the appliance for
assembly and installation. Several methods may be used to attach the legs and pedestal to the appliance. The safest method is to roll
the appliance on its back, then attach the chosen assembly. When using this method, you should
fi
rst remove the
fi
rebrick from the
unit so as to reduce weight and possible breakage. It will be required to raise the bottom of the unit up to attach two of the legs or
the pedestal. It is recommended that you use cardboard or other means of padding to protect the
fi
nish on your new stove.
FREESTANDING LEG ASSEMBLY
1)
Unpack the kit and ensure all components are present:
Qty
Description
Part
#
4
Cast Iron Legs
40566
8
1/4-20 UNC Bolts
83339
8 Flat
Washers
83045A
2)
Position the unit for assembly.
3)
Using the Eight(8) 1/4-20 bolts and washers provided, attach the legs.
4)
Rotate the appliance onto the legs, being careful not to damage the
legs while doing so.
5)
Make sure that the baf
fl
e board, above the air tubes, is in place and
undamaged. DO NOT remove the baf
fl
e board.
6)
Install the screw provided in the parts bag into the secondary air
damper, where shown.
FREESTANDING PEDESTAL ASSEMBLY
The pedestal should come assembled to the base, ready to install on your appliance. You can either roll the appliance onto its back
as above or locate the pedestal assembly in the approximate
fi
nal location, then
set the appliance atop the pedestal.
Caution! The appliance is very heavy.
1)
Unpack the Pedestal Assembly and ensure all components are present:
Qty
Description
Part #
1
Pedestal Assembly
8
#10x1/2 Hex Head Screw
83343
2)
Position the appliance for assembly.
3)
Attach the pedestal to the bottom of the unit using Two (2) bolts provided.
4)
Attach the pedestal back to the pedestal using four(4) sheetmetal screws
provided.
5)
Make sure that the baffle board, above the air tubes, is in place and
undamaged. DO NOT remove the baf
fl
e board.
6)
If an outside combustion air source is needed see the
“5.1 Combustion
Air Assembly Instructions”
section in this manual.
Damper retaining screw