ASEA AC100LC-3, Руководство по эксплуатации

Страница: 7 / 75

AC90LC-3, AC100LC-3, and AC125LC-3 Operations Manual....
7

THIS EQUIPMENT CONTAINS HIGH ENERGY, LOW IMPEDANCE CIRCUITS!
LETHAL POTENTIALS ARE CONTAINED WITHIN THE SYSTEM EVEN WHEN IT
APPEARS TO NOT BE OPERATING.

CARE MUST BE EXERCISED WHEN SERVICING THIS EQUIPMENT IN ORDER TO
PREVENT SERIOUS OPERATOR INJURY OR EQUIPMENT DAMAGE.

DO NOT WORK ON OR OPERATE THIS EQUIPMENT UNLESS YOU ARE FULLY
QUALIFIED TO DO SO. NEVER WORK ALONE.

THE EQUIPMENT IS NOT IGNITION RATED, IT MUST NOT BE OPERATED IN AREAS
WHERE COMBUSTIBLE GASES MAY ACCUMULATE.

THIS EQUIPMENT CONTAINS HYDRAULIC FITTINGS AND EMPLOYS A COOLANT
OIL. DO NOT ATTEMPT TO SERVICE THE HYDRAULIC SYSTEM WITHOUT THE
ASSISTANCE OF FACTORY AUTHORIZED PERSONNEL.

THE HEAT EXCHANGER HAS WATER SYSTEM THAT IS UNDER PRESSURE. NEVER
OPEN THE WATER CONNECTIONS UNLESS THE WATER SYSTEM HAS BEEN SHUT
OFF AT IN THE SUPPLY AND RETURN LINES.

OBSERVE THE FOLLOWING WHEN SERVICE AND MAINTENANCE ARE REQUIRED:

REMOVE ALL JEWELRY FROM ARMS AND NECK WHEN SERVICING THIS
EQUIPMENT. THIS PREVENTS THE POSSIBILITY OF SHORTING THROUGH THE
JEWELRY, OR ELECTROCUTION OF THE OPERATOR.

WEAR SAFETY GLASSES WHEN SERVICING THIS EQUIPMENT TO PREVENT EYE
INJURY DUE TO FLYING PARTICLES CAUSED BY ACCIDENTAL SHORT CIRCUIT
CONDITIONS .

DO NOT REMOVE ANY PANELS OR COVERS WITHOUT FIRST OPENING ALL SHORE
POWER AND SWITCHGEAR CIRCUIT BREAKERS DISTRIBUTING POWER TO AND
FROM THE CONVERTER, AND THEN REMOVING THE INPUT SERVICE.

SERVICE SHOULD BE REFERRED TO PERSONNEL AUTHORIZED BY THE FACTORY
TO SERVICE THIS EQUIPMENT.