ASEA AC100LC-3, Руководство по эксплуатации

Страница: 46 / 75

AC90LC-3, AC100LC-3, and AC125LC-3 Operations Manual....
46
SHORE CORD SETUP CONV.CAPACITY:125.0kVA
MASTER CORD CAPACITY: 200 Amps
VOLTAGE: 400 Vac, FORM: 3
Ø
, Freq.: 50Hz
More Less Exit
7.3 LOAD MANAGEMENT OPERATION, cont.
7.3.2 Shore Cord Setup , Single, Master, or Slave Converters
The Shore Cord Setup screen is used to set the actual shore cord ampacity based on the marina’s
dock or pedestal circuit breaker. The converter’s new, programmed CONV. CAPACITY is then
displayed for reference. The converter’s Load Level and Power indicators for Shore Power and
Converter Power will then display the actual converter capacity usage based on the programmed
CONV. CAPACITY.
It is important to understand that this is an indication device, and affects reporting and alarming only.
The peak and average overload capabilities are not affected by this setting. Dynamic response to
loading and equipment startup surges is unaffected. The intent here is to prevent tripping of
dockside circuit breakers by average loading when a smaller than desired shore supply is used.
From the front panel, press the SHORE POWER + F2 buttons, and then Cord ( F1 ) to access the
following screen:
Press More ( F1 ) or Less ( F2 ) to adjust the MASTER CORD CAPACITY, and Exit ( F5 ) to save the
settings and exit the screen.
Default Range Units
CONV. CAPACITY true capacity based on cord capacity, voltage, and form kVA
CORD CAPACITY 250 30, 32, 50, 60, 63, 100, 125, 150, 200, 250 Amps
The CONV. CAPACITY is calculated as:
V
L-L

A
 
3
and is never greater than the converter’s
actual rating if the shore supply size has a greater capacity than the converter.