ascon A5RT 120 BR, Руководство пользователя

Страница: 17 / 67

15
(f) Installation Clearance
Refer diagram below for the space required around the unit. Note that:-
(a) All dimensions shown are in mm.
(b) All space value shown are minimum clearance required for the unit.
(c) Unit shown in the diagram is A5RT90BR. Other models shall follow the same clearance.
(d) Unit Lifting
Holes at 4 corners of the unit base are used for unit lifting
purpose.
The spreader bar shall be slightly wider than the unit width.
The insulation should be added at 4 corners of the chain
to prevent the damage of the panel when lifting.
Note:
Unit shown in diagram is A5RT90BR.
Other models will follow the same method in lifting.
(e) Drain Piping
•
A 1" MPT condensate drain fitting is provided. The
drain pipe can be led out at the front side.
•
The drain pipe must be provided with a trap on the
outside of the unit and also installed at an incline
for proper drainage, as shown in the right.
•
To prevent condensate formation and leakage,
provide the drain pipe with insulation to safeguard
against sweating.
•
Upon completion of piping work, check that there is
no leakage and that the water drains off properly.
Chain
Lifting beam
Spreader
bar
Lifting holes for
shackle (4 corners)
Condenser
air outlet
3000
Condenser
air inlet
00
21
1200
Blower & motor
service
Air filter
service
Evaporator coil
service
1200
Electrical control
circuit service
Compressor service
The drain piping should have a drain trap.
Drain piping
The drain pipe
should extend
below this level.
Drain trap
A
B
C
Note: E.S.P = External Static Pressure
Drain trap for condensate
A
≥
70mm
B
≥
2C
C
≥
2XE.S.P