Operating Instruction Ascoline 850, MEH 2xx, 4xx, 6xx
ascobloc
astro-Gerätebau GmbH
01156-Dresden, Grüner Weg 29
Deutschland
Tel. : (0351)4533-0
Fax (0351)4537-339
E-Mail:
MEH2xxff_e.doc, Stand: 18.1.2012
Subject to change without notice!
4
Front view – Position in the rear wall for circular holes to come through with the cable
5 Proper Use of the Equipment
5.1 Bringing into use
Remove the protective film before bringing into use.
Clean the equipment with dilute soap solution.
Before using the oven for the first time it must be operated once for approx. 1 hours at maximum setting
without food and with closed oven door. Make sure that the appliance is only operated in a well ventilated
room!
5.2 Operation
5.2.1 Steel Hot Plates
Use only pans with smooth bottom. Rough bottoms scratch the surface when moving, otherwise the
temperature transfer with smooth and flat bottom is more effective
Turn the knob for thermostat to the right. The cooking zone heats up and the green pilot lamp lights up.
After some minutes in open circuit the heating of the cooking zone is lowered.
Initial cooking at high output settings, continuous cooking at lower setting. The required setting for
continuous cooking depends on the pan type and quantity of food to be cooked.
Turning the knob to the right you will have 4 heating zones
Heating zone I
900W
Heating zone II
1500W
Heating zone III
2200W
Heating zone IV
3500W
To switch the appliance off turn all control knobs to ”zero”.
Advises to save energy
•
Use only pans with smooth bottom.
•
Keep the cooking zone at the lowest setting on stand by.
•
Choose a pan with a diameter fitting to the cooking zone.
•
For keeping the pan warm pull it on the next cooking zone to use its after-heat.
