INSTALLATION
IM14229-6
GB
2
PE
ØM4
CAUTION - BE SURE TO FOLLOW THESE INSTRUCTIONS!
1) The coil must only be supplied with 24 V DC ±10 % and a max. ripple of 10 % (no supply via
diode bridge). Overvoltage or a ripple rate exceeding 10 % can damage the electronics.
2) The max. current at pin 7 is 500 mA (NPN/PNP output). Pin 7 is protected against short circuit
and overload.
3) If a relay (inductive load) is connected to the pressure switch output, a freewheel diode or a
varistor must be used.
4) Do not solder
unused pins on the connector.
5) In case of an interruption in the pressure supply, shut off the power supply (+24V) or switch
the set point to zero to avoid excessive heating of the coil.
6) Grounding for personal protection must be done at the PE terminal (ØM4) on the body (see
diagramme opposite).
7) Use a shielded cable for EMC protection. Connect the shield to ground and to the connector
body.
!
+24V
Supply voltage
Supply voltage GND
Setpoint
10V (or 0-20 mA or 4-20 mA)
Setpoint GND
(Output)
Not used
Outlet pressure feedback
0-10V (or 0-20mA or 4-20mA)
PRESSURE SWITCH OUTPUT
NPN if setpoint
is reached
PNP if setpoint
is reached
NPN if setpoint
is not reached
PNP if setpoint
is not reached
NPN
Feedback = Setpoint
+ 30V max.
+ 30V max.
0V
I = 500 mA max.
I = 500 mA max.
I = 500 mA max.
I = 500 mA max.
PNP
Feedback = Setpoint
NPN
Feedback ≠
Setpoint
PNP
Feedback ≠
Setpoint
Connector on
electronic card
NPN
PNP
NPN
PNP
7-pin DIN connector
View on solder side
of female connector
or
or
or
