Ascent AT5200 FTTX EDFA, Краткое руководство пользователя

Страница: 17 / 29

AT5200 FTTX Multiport EDFA
Solutions Provider for FTTx, RFoG, and HFC www.ascentcomtec.com Page 17 of 29
3. Set the IP address
Select the menu that need modification, press

button enter into sub menu, then press

button enter into menu modify status, press
▲
/
▼
button to increase/decrease the value,
press

button to shift the value, at last bit press

button to save, and press

button back to
main menu.
4. LCD Contrast Level (Set the LCD contrast level)
Select the menu that need modification, press

button enter into sub menu, then press

button enter into menu modify status, press
▲
/
▼
button to set LCD contrast level, press

button to save, and press

button back to main menu.
AT-52-EDFA series provide the following management ports:
RS232 port: be suitable for examining AT-52-EDFA parameters and some system configuration
by PC machine RS232 port.
SNMP: Simple network management protocol
Before connection AT-52-EDFA series of the port, please read the following instructions and
port connectivity requirements.
The AT-52-EDFA series management port connector type is RJ-45.
Figure. RJ – 45 Connector Plug and Socket
The Management port (RJ-45) can be connected to any device that uses a standard network
interface (e.g., a workstation, server, bridge or router). RJ-45 MDI can be connected with
similar network equipment (such as other AT-52-EDFA or network Hub). Use unshielded
twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45 connections: 100-ohm
Category 3, 4 or 5 cable for 10 Mbps connections or 100- ohm Category 5 cable for 100 Mbps
connections. Beside, please ensure that the cable length does not exceed 100 meters.
1
8