4
Before Starting Centrifuge
The main switch is located on the lower right side of the centrifuge.
Before starting up the centrifuge for the first time, make sure that the rotor locking
knob is securely fastened.
Safety Precautions
Always
The rotor and lid must
always
be securely fastened.
If the centrifuge makes unusual noises
when started, or exhibits excessive
vibration, switch the unit off
immediately
by turning the power switch OFF.
The centrifuge
must be loaded symmetrically
.
Do not use centrifuge with wet hands.
Take all precautions when using the centrifuge for toxic, radioactive, or material
with pathogenic micro-organisms, with respect to your safety and the safety of
others.
Do not place any sample containers or test tubes directly into the rotor.
The Centrifuge Itself
Do not use a centrifuge that was not correctly installed or repaired.
This centrifuge may be used only for the specified application. It must not be
operated in a hazardous or flammable environment and must not be used to
centrifuge flammable, explosive, or highly reactive substances.
When moving a centrifuge from a cold room to one of normal temperature, run
the centrifuge for 30 minutes in the cold room so that it does not get covered in
condensation. Alternatively allow it to warm up for at least three hours,
unplugged, in order to prevent condensation.
The rotor and polycarbonate carrier are high-grade components which are
subject to extreme mechanical stress. Slight scratches, tears, dents, or other
damage can lead to failure of the centrifuge.
All material associated with the centrifuge should be protected from excessive
ultra-violet radiation.
Reminders
If any function of the centrifuge does not operate correctly do not use the
centrifuge.
Do not use a damaged centrifuge.
Do not move the centrifuge during the run.
After prolonged use, or if the motor was stalled, the bottom of the centrifuge may
become very hot. Handle the centrifuge by the sides only.
