11
E
n
gli
s
h
8.1 Wheel alignment
If you tighten the chain after replacing the rear wheel,
make sure that both the front and rear wheels are aligned
with each other after assembly. Checking alignment:
From the front of the bike, point the handlebars straight
and using your line of sight, check that the front and rear
tyres line up. Otherwise use a straight board butted up
against the tyres to check for alignment. If the wheels are
out of alignment with each other it will be hard to steer
and control the bike.
Ensure that re-assembly was done correctly and check
that the brakes are functioning properly before riding.
9. Care and maintenance
• Clean your bicycle regularly. Use warm water and a brush or sponge for cleaning. Try to avoid
using a high pressure washer for cleaning as the water jets may penetrate the ball bearing
housing and shorten the life of your bike.
• Regularly check that all screws and nuts are securely tightened. See
2. Product description.
• Clean the chain with a brush and dry with a cloth.
• It is important that the chain, gears, wires and other moving parts are well lubricated with
proper lubrication.
•
Note:
Make sure that the chain is correctly tensioned. Free play from the chain’s midpoint
should not exceed 20 mm.
• Regularly check for brake wear and proper operation.
• Replace the brake pads when worn. If the brake pads are not completely worn, adjust
the brake wire to improve braking performance.
• If your brakes don’t grip properly, it may be that the handlebar post or handlebars are loose
or that your wheels are warped - leave your bike in for service at any Clas Ohlson Store or
call Clas Ohlson’s Customer Services for assistance.
• Check both front and back lights and that all reflectors are whole and clean.
• Inflate tyres to their recommended pressure as marked on your tyre’s sidewalls.
• Make sure that no sharp stones and similar objects are caught in your tyres and that there is
no other visible damage.
• Store your cycle in a sheltered environment. This will prolong the life of your cycle
considerably.
9.1 Winter storage
• If you need to store your bicycle for any longer period, such as in winter, it should be stored
in a dry frost-free environment.
• Make sure that your tyres are properly inflated.
• Remove any batteries from your lights, otherwise there is a risk that they can leak and
cause damage.
• Make sure to wipe your rims when taking your bike out of storage as these can collect dust
and interfere with the proper functioning of your brakes.
10. Disposal
This product should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local council.
