Asada CLEAR SCOPE 2820, Инструкция по эксплуатации

Страница: 23 / 24

CLEAR SCOPE 2820
BEFORE ASKING FOR REPAIRS
●Before asking for repairs, check the device with the following troubleshooting.
If the problem cannot be solved, contact the shop you purchased or our sales office.
●Troubles due to misuse or improper applications are not covered by warranty.
Symptom Possible Reason Solution
No image
Low battery charge Recharge battery
Dead battery Replace in our shop
Poor LED lighting
Increase the LED brightness by
turning the LED Intensity
Adjustment clockwise.
Loose cable connection
Connect the Camera Cable
and the Display Unit properly.
Fault in the Display Unit Repair or replace in our shop
Wiring disconnection in the
LCD Monitor
Repair or replace in our shop
Fault in the Camera Head Repair or replace in our shop
Camera Cable is broken Repair or replace in our shop
Image is dark.
Too far to the object Move the Camera near the object
LEDs are out Repair or replace in our shop
The LCD Monitor is exposed to
direct sunshine
Avoid direct sunlight
Image is unclear The object reflects the light
Turn down the LED brightness
Image cannot
be recorded
No SD card Insert a SD card
The SD card is full
Delete some data or insert a new
SD card
Button cannot be
push
Stuck with sands and so on
Remove the sands around the
button.
Image noise The lighting is not enough Brighten the LED light
Whitish image The lens is not clean Wipe the lens with a soft cloth
＊ When all functions freeze or fail, insert an insulated needle
into the hole on the back of the LCD Monitor.
The system will restart automatically.
Reset
修
理
・
サ
ー
ビ
ス
を
依
頼
さ
れ
る
前
に
23