AS MOTOR WeedHex AS 50, Руководство оператора

Страница: 13 / 36

13
Information on brushing
Prior to brushing, check the device for com-
pleteness, proper function, and cleanliness. A
dirty ventilation grid causes overheating of the
engine which can result in engine damage. A
dirty protective grid at the silencer poses a fire
hazard.
During brushing, wires can be left behind. Re-
move these wires after the work is completed.
Brush only areas where remaining wires do not
pose a hazard.
Performance depends mainly on the type and
degree of contamination.
The ideal engine speed is fixed.
If the engine speed drops significantly during
removal of thick growth, we recommend:
– Reduce the driving speed.
– Pull back the device and brush over the area
for a second time.
– Reduce the brush pressure and brush over
the area for a second time.
If the engine speed drops significantly during
working on uneven surfaces, we recommend:
– Reduce the brush pressure.
– Brush the area, if possible, for the second
time, in a different direction.
Do not move over edges or steps when the en-
gine is running.
To prevent excessive dust formation, operate
the device preferably when weather conditions
are humid. If this is not possible, wear a dust
mask or sprinkle some water on the area.
To make sure that weeds and dirt are ejected
without clogging, we recommend to brush only
while moving forward.
Prior to starting
Fuel
As fuel, use unleaded petrol (see operating in-
structions of the engine manufacturer).
You can use E10 petrol. Do not store E10 pet-
rol longer than 30 days.
Tanking up
Warning
Fuel is ignited by hot engine parts.
► Prior to filling up, switch off the engine
and wait for at least 20 minutes until the
engine has cooled down. Observe the
safety instructions regarding the fuel!
Filling up with fuel
1. For filling, use a canister with filler spout or
a funnel.
2. Open the canister carefully so that existing
excess pressure is slowly reduced.
3. Open the tank cap carefully so that existing
excess pressure is slowly reduced and no
fuel sprays out.
4. Fill the fuel tank.
5. Tightly close the tank cap again.
Checking the engine oil level
Beware! Prior to each use, check the engine
oil level (see operating manual of the engine
manufacturer).
To ensure an adequate oil supply for the
4-cycle engine and to avoid engine damage,
the device may only be used up to a slope in-
clination of 20 degrees.