7.7 Adjusting orresetting the Bowden cables
WARNING!
Switch off motor and allow to cool down. The machine must be secured against unintentional starting.
Care and maintenance
36
1) Loosen the top nut with a 10 mm ring spanner
(approx. one turn).
4) Brush drive - Movement drive (forwards)
After 140 mm empty run you must be able to feel
a distinct resistance.
3) Then tighten the nut. Check the adjustment you
have made by pressing the lever down.
IMPORTANT!
It may be necessary to reset the Bowden cables after machine has been operating for a few hours.
If the adjustment is not the Bowden enough, you should contact your local dealer.
2) The throttle cable with an 80 mm ring spanner set.
4) Reverse gear:
After 80 mm empty run you must be able to feel a
distinct resistance.
140 mm
80 mm
If the adjustment has not been made correctly, please repeat steps 1) bis 3).
