25
Assembly AS 21 4T Comfort
Unpacking
1. Remove the loose parts from the box (pro-
tection bow, protection skirt, side panel,
front wheel, and cardboard inserts).
2. Cut open the front side of the box.
3. Bring the handlebar up (see guide bar and
handlebar).
Guide bar and handlebar
1
2
3
5
4
Fig. 14:
1. Swing the guide bar (
1
) back.
2. Slacken the hexagon nut at the eccentric
lever (
2
).
3. Attention: Do not crush the Bowden
cables (
3
) when pivoting the handlebar.
Swivel the handlebar (
4
) in an anti-clock-
wise direction backwards and clamp it
down with the eccentric lever (
2
).
4. Turn in the hexagon nut until the eccentric
lever (
2
) can be tensioned with normal
force and is parallel to the guide bar.
5. Adjust the guide bar by pulling the tied
rod (
5
) to the desired height. Make sure
that the Bowden cables are laid without any
tension.
6. Push the device out of the box on its rear
wheels.
Protection skirt and steerable front
wheel
1. Apply the side panel (
1
) on the left front
blade hood side to the welding screws.
2. Fasten the side panel onto the rear
screw (
2
) with a nut M6 and a washer.
