24
2. Screw the handlebar in place with the
tommy screw (
2
) and a disc.
3. Attention: Make sure that Bowden cables
(
3
) are not crushed.
4. Pull the device out of the carton, rolling it
on its rear wheels.
Protection skirt and steerable front
wheel
1. Apply the side panel (
1
) on the left front
blade hood side to the welding screws.
2. Fasten the side panel onto the rear
screw (
2
) with a nut M6 and a washer.
3. Place the protection skirt (
6
) over the pro-
tection bow (
3
).
4. Apply the protection bow (
3
) on the right
blade hood side to the screw M8 (
4
).
5. Screw in the protection bow at the front
hole (
5
) of the side panel with a screw M6,
washer and nut. Make sure that the rear
hole of the protection bow coincides with
the rear hole of the side panel (
11
).
6. Turn the bow holding device (
7
) upwards to
the middle.
7. Push the steerable front wheel (
8
) with the
tube end through the bow holding
device (
7
) and insert it into the guide
bar (
15
).
8. Screw down the steerable front wheel with
the toggle screw (
14
).
9. Hang the protection skirt in the screws (
9
)
on the blade hood and screw it down with
washers and nuts.
10. Screw down the protection bow and the
protection skirt at the right side of the blade
hood (
10
) with a washer and a retaining
nut.
11. Insert the rear screw M6 at the side
panel (
11
) and screw down the protection
bow and the protection skirt.
12. Fasten the protection skirt at the protection
bow with the cable ties (
13
). Use one cable
tie for each opening provided in the protec-
tion skirt.
13. Close the overlapping protection skirt with
a cable tie.
