ARUSNAVI ELECTRONICS ARNAVI 5, Руководство пользователя

Страница: 52 / 56

USER MANUAL [1.4] Page 52
DESCRIPTION OF PARAMETERS IN THE WIALON SYSTEM
Prameter
Wialon
Parameter
Geliospro
Description Comments
pwr_ext BU External power supply voltage
pwr_int RBU Internal battery voltage
hdop hdop Horizontal Dilution of Precision
cell_id GSM Base station unique ID
lac GSM Location area code
mnc mnc GSM Mobile network code
mcc mcc GSM Mobile country code
gsm gsm GSM Signal level Range from 1 to 31 (99 – no service)
gsm_st gsm_st GSM module state 0 – turned off, 1 – turned on, 2 – AT Ok, network
search, 3 – GPRS test, 4 – GPRS OK
nav_st nav_st GPS module state 0 – turned off, 1 – turned on, 2 – satellites search,
3 – satellites captured
mw mv Accelerometer sensor state 0 – no move, 1 – move
sim_t sim_t Active SIM card number 0 – SIM1, 1 – SIM2
sim1_st sim1_st SIM-1 state 0 – no SIM, 2 – network search, 1 – home
network, 5 - roaming
sim2_st sim2_st SIM-2 state 0 – no SIM, 2 – network search, 1 – home
network, 5 - roaming
s1_st S1_st Server 1 state 0 – not defined, 1 – connection attempt,
2 – connection established
s2_st S2_st Server 1 state 0 – not defined, 1 – connection attempt,
2 – connection established
os os Penetration sensor state 1 – activated, 0 – not activated
v_in ign_virt Ignition
Считывается с IN4(при подключенном CAN –
считывание ведется с CAN-шины)
msd msd MicroSD availability 1 – installed, 0 – not installed
bt BT Bluetooth state 1 – on, 0 - off
gyro gyro Gyroscope state Optional
call_btn Call button state 1 – pressed, 0 – not pressed
gps_full_
mileage milleage Full mileage according to the GPS
module
freq_X FREQ_X Frequency value on discrete input X – input number (For example, freq_4 –
IN4(A4))
info_messages im1 Info message tag Displays the reason for recording a new package
lls1_val LLS_1_L RS485 fuel level 1 – sensor number
lls1_temp LLS_1_T RS485 temperature 1 – sensor number
volt_X VOLT_X Voltage value on analog input X – input number (For example, volt_4 –
IN4(A4))
pin - Bitwise parameter
(in
X /out X state)
Bitwise state of discrete sensors (for
inputs IN0-IN9, number IN+1).
For example, to monitor the status of IN4, the
parameter to create the sensor pin:5 (which
means: control the fifth bit of the parameter ‘pin’)
- in X Discrete inputs value X – number IN (IN0(device)= in0 in Geliospro)
Mbus_X Modbus register value X- register number( 0-19)
Imps_X Pulse sensor value X – discrete input number
ID i-button key id
Temp_1Wire_X Temperature sensor value X – temperature sensor number