24
| Specifications, Safety, and Compliance
Aruba Mobility Master Hardware Appliance
| Installation Guide
This product complies with 21 CFR Chapter 1, Subchapter J, Part 1040.10, and IEC 60825-1: 1993,
A1: 1997, A2: 2001, IEC 60825-2: 2000.
For continued compliance with the above laser safety standards, only approved Class 1 modules
from our approved vendors should be installed in the product.
Electromagnetic Interference
United States
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at their own expense.
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Canada
This Class A digital apparatus complies with Canadian ICES-003.” & “Cet appareil numérique de la
classe A est conforme à la norme NMB-003 du Canada.
Europe
CLASS 1
LASER PRODUCT
Use of controls or adjustments of performance or procedures other than those specified in this manual may
result in hazardous radiation exposure.
Although this appliance has been tested up to 1kV per CE immunity requirements, this product requires surge
protection to be provided as part of the building installation to protect against unidirectional surges resulting
from electrical switching and lightning strikes.
For protection against these surges in an outdoor installation, any exposed wiring must be shielded, and the
shield for the wiring must be grounded at both ends.
This is a Class A product. In a domestic environment, this product may cause radio interference in which case
the user may be required to take adequate measures.
