20
| Installation
Aruba Mobility Master Hardware Appliance
| Installation Guide
2. Pull the tab on the power supply module towards the left and slide it out using the handle (see
Figure 11
).
3. If you are not replacing the power supply module immediately, ensure to install a filler panel that
was included with your Mobility Master hardware appliance. To install the filler panel:
a. Align the filler panel with the opening in the appliance.
b. Slide the filler panel into the appliance.
c. Turn the screws on the filler panel clockwise until tight to secure the filler panel into the
appliance. (see
Figure 12
).
Figure 11
Removing a Power Supply Module
Figure 12
Installing a Filler Panel
Connecting and Removing an SFP/SFP+/LC Cable
SFP/SFP+ modules are collectively referred as SFP modules in this section.
Step 3 on page 20
is mandatory if you do not have a replacement power supply module. If you have a replacement
power supply handy, skip
Step 3 on page 20
and proceed to
“Installing a Power Supply Module” on page 19
.
Use standard ESD precautions when installing or removing an SFP.
