Aruba 800-E, Руководство по установке

Страница: 26 / 52

Initializing the 800-E
Chapter 3
18 Aruba 800-E 0500191
Installation Guide November 2005
The setup dialog will prompt you for all necessary information. Defaults are
available for some prompts, and are shown in parenthesis. To accept a default
value shown in parenthesis, press <Enter>. If you make a mistake, you can either
power off, then power on the switch to restart the setup dialog, or you can
proceed to the end of the script where you will have the option to repeat the
script (by entering
r ).
In cases where complex options are available, this guide recommends the default.
Once your switch is operational, you can modify it with information contained in
the
AirOS User Guide .
Setup Dialog Prompt Description
Enter System name [Aruba800-E]:
Assign a name to your switch. The
example shows the default name
for an Aruba 800-E Access
Multiplexer.
Enter VLAN 1 interface IP address
[172.16.0.254]:
Enter the appropriate IP address
for your VLAN 1.
Enter VLAN 1 interface subnet mask
[255.255.255.0]:
Enter the subnet mask for VLAN 1
interface, or press
Return
to accept
the default.
Enter IP Default gateway [none]:
Enter the appropriate IP address
for your default gateway or press
Return
to accept the default (none).
Enter Master switch IP address:
You must define which switch will
act as master for this local switch
by telling this local switch the
address of the master Access
Multiplexer.
Enter the loopback IP address of
the master if a loopback IP address
is configured. If not, then enter the
master switch VLAN 1 IP address.
Proceed with the password for
admin login.
Enter Mobility Controller IP address:
The IP address of the Mobility
Controller that terminates the GRE
tunnel and which can be the same
as the Master switch. The 800-E
will be recognized by this switch’s
Master Switch as another local
switch.