© 2004 – 2021 ARTRAY Co., Ltd
991SWIR-TEC-CL
Camera Link
Setting Manual
3
Rev.1.00
1.
Introduction
This manual is for overall settings of cameras with Camera Link. Please refer to the camera
instruction for more details of cameras.
This manual is especially for the following model:
Table 1-1: Target Model
Model
Pixels
Frame Rate
ARTCAM-991SWIR-TEC-CL
0.32M
137fps
2.
Device and System Requirements
To use a Camera Link camera, the following devices and software are required. Please have them
prepared before starting up the camera.
Table 2-1: Minimum Requirements
Item
Note
Camera Link Frame Grabber Board
Compatible with Base Configuration
Viewer Software
Software accompanying with grabber board,
or ArtMeasure
Serial Communication Software
e.g. Tera Term
PC
Any which can adopt items mentioned above.
Camera
Camera Link Cable
The connector joining to camera should be SDR.
AC Adapter
Please use the AC adapter we offer
All the settings in this manual are under the condition with following devices which we recommend.
While using other devices, users could adapt settings correspondent to the devices.
Table 2-2: Device and System recommended
Item
Recommendation
Camera Link Frame Grabber Board
PIXCI®EB1 (Manufactured by EPIX)
Viewer Software
XCAP for Windows Lite
Serial Communication Software
Tera Term
Operation has been confirmed using the following framegrabbers and software combinations.
Table 2-3: Tested Framegr Software
Manufacturer
Product name + software
NI
NI PCIe-1433 + NI MAX
AVAL
APX-3318 + AcapLib2Viewer
Dalsa
Xcelera-CL PX4 Full + CamExpert
EPIX
PI XCAP
※
Tested CameraLink cable length: 2m
