If the logo does not appear, the projector battery is likely not charged. To charge the
device, simply plug the charging cable into the “DC” port in the back of the projector. You
can use the projector while it is charging.
1. Powering on the device:
Turn the device “ON” using the switch on the
left side of the projector. Set the device up so
that the lens is facing a wall.
After a few seconds, the “Artograph Flare 450” logo should begin projecting. This means
the projector is starting correctly.
A green light indicates the projector is fully charged, a red light indicates it is charging.
