13
POWER AND CONTROL
Ethernet: PoE connector.
Use the power supply to power the device. Connect an Ethernet CAT6
shielded cable to Output on the power supply, then connect the CAT
cable AHnet connector to the microphone lift. For remote control using
the AHnet, connect a CAT6 shielded cable to the Input on the power
supply and then connect the cable to your network. Connect the
power supply to your power source.
The device is powered and connected to your net network. Minimum
power required 30W PoE.
Remote control, see AHnet protocol.
SETTINGS
Dip1: AHlink ON/OFF
Position Down: AHlink active
Position Up: AHlink not active
(Leave the rest of the deep switches on up position)
SERVICE: USB, service only
MIC: Microphone RJ45: SHURE MXA310 RJ45 connector
