3
1. Installation of computer light.
Using eight M10 size bolts, through making use of bracket that
owned by computer light install. Make sure the firmness of
installation, in case swing or glide happen when it works. Each
weight of computer light is 18.5KG more or less. Before installation,
it should be ensure if frame can support the weight. For safety, a safe
chain should be through the side handle of lighting body.
Notice: please don’t use the die down yoke of computer light to rise,
to lower, and move it.
2. Installation of lamp.
loosen plastic body which locate in luffing structure of computer
lighting body, and strengthen screw of right-and-left cover shell, then
open the cover forth gently, at the tail of shine lamp, screw off four
coppery screw and move metallic gobo flag and heat guard of two
sides, then can replace lamp. When install it, please use HMI575W
modulator tube. Pay attention to screw down the screw of two sides of
lamp, or it cause high voltage short circuit and discharge for poor
contact. It influence service life of lamp, and damage components of
circuit board. After finish it, please strengthen the metallic gobo flag
and heat guard of two sides of lamp firstly. Then using adhesive tape
to fold covering shell, and strengthen screws of right-and-left of it.
MSD light products are provided with high voltage modulator tube
what has exterior igniter. When operate these modulator tubes, it must
be careful, and should read the instruction of modulator tube that offer
by manufacturer before operation.
Warning 1: Don’t forget install metallic gobo flag and heat guard that
beside the lamp or thermal radiation is easy to bake the plastic shell
distortion. Seriously, it will raise fire alarm. Manufacturer will not
responsible for these losses.
Warning 2: Modulator tube will reach to a high temperature when it
works, and the trait of gas discharge lamp can not intermittent power
