Artesyn Embedded Technology Centellis 2000 Series, Инструкция по установке и эксплуатации

Страница: 41 / 60

Chapter 3
Centellis 2000 User Card 10GE with Telco Alarm Installation and Use (6806800M46C)
41
Controls, Indicators and Connectors
3.1 Face Plate
The following figure highlights the position of LEDs and connectors on the face plate of the
board. The LEDs and connectors are described in sections
LEDs on page 41 , Ethernet Connectors
on page 42 , and Telco Alarm Connector on page 42 .
3.1.1 LEDs
The following LEDs can be found on the face plate of the board. OOS, OK and H/S are ATCA LEDs
and can be controlled via IPMI. For more information, refer
Centellis 2000 User Card 10GE with
Telco Alarm: Control via IPMI Programmer’s Reference manual.
Figure 3-1 Face Plate
Table 3-1 Face Plate LEDs
LED Color Description
OOS (failure) Red Red: The Centellis 2000 User Card 10GE with Telco Alarm is
out-of-service.
Off: The Centellis 2000 User Card 10GE with Telco Alarm is
working properly.
OK (power) Green Green: The Centellis 2000 User Card 10GE with Telco Alarm
is operating properly.
Off: Otherwise
Blinking: The board boots up.
H/S Blue Blue: The Centellis 2000 User Card 10GE with Telco Alarm is
ready to be extracted.
Off: The Centellis 2000 User Card 10GE with Telco Alarm is
not ready to be extracted. Do not remove the board during
this state.