Artel INFINITYLINK ILC205, Инструкция по установке и эксплуатации

Страница: 25 / 32

ILC205 Function Module Installation and Operations Manual 15
Monitoring ILC205 Operations
Table 8. ILC205 Front and Rear Panel Status LEDs
LED Indicates . . . State Description
SFP1/SFP2 RX SFP link status Off SFP disabled.
Green Link established.
Green (flashing) Data activity.
Yellow (flashing) RX optical power high.
Red (flashing) SFP RX fault, low light, or loss of signal.
Red Loss link alarm, if enabled.
Monitoring Using InfinityLink Manager
This section shows how to use InfinityLink Manager to view the module’s current configuration, major and
minor alarm status, and the optical status of SFP1 and SFP2.
Prerequisites
To monitor the ILC205 module using InfinityLink Manager, you must access the InfinityLink Manager that
manages the module. For details about accessing and setting up InfinityLink Manager, see the
InfinityLink Manager Setup and Operations Manual .
Procedure
To monitor the ILC205 module operation, perform the following steps:
1. From a browser window, enter the IP address of the InfinityLink Manager that manages the module.
The Home page displays.
2. From the Home page menu bar, click
Shelf View
.
The Shelf View page displays, which shows the rear chassis panel along with the Installed Modules table.
3. From the Installed Modules table, click the ILC205 link listed in the Module Type column.
The Module Status page displays, which shows the following information:
•
Current Configuration
: Displays the following information for the rear panel’s RJ45 connectors,
Ports 1 to 3:
– Link —Line status: UP or DOWN.
–
Rate Limit
—Configured setting: 1 GB/S, 100 MB/S, 10 MB/S, AUTO (auto-negotiate)
– Rate —Detected rate.
–
Duplex Limit
—Configured setting: FULL or HALF DUPLEX.
– Duplex —Detected duplex usage.
–
Alarms
—Configured setting: Enabled or Disabled.
• Alarms : Displays detected Major and Minor alarm conditions if any exist.
(Continued)