Artel INFINITYLINK ILC205, Инструкция по установке и эксплуатации

Страница: 18 / 32

8 ILC205 Function Module Installation and Operations Manual
ILC205 Function Modules
Procedure
To configure the ILC205 module operation, perform the following steps:
1. From a browser window, enter the IP address of the InfinityLink Manager that manages the module.
The Home page displays.
2. From the Home page menu bar, click
Shelf View
.
The Shelf View page displays, which shows the rear chassis panel along with the Installed Modules table.
3. From the Installed Modules table, click the
Configuration
link associated with the ILC205 listed in the
Module Type column.
The Configuration page displays.
4. From the Physical Layer Configuration panel, configure the module’s physical port connections as
described in the following table.
Table 2. Physical Layer Configuration Parameters
Parameter Setting Description
P1 to P3
(RJ45 connectors Enable (Check/
Uncheck) Check the checkbox to enable the port or uncheck it to disable
the port. The default is
Enabled
.
Rate Limit Select the appropriate port rate limit: 1 Gb/s, 100 Mb/s,
10 Mb/s,
or
Auto
. The default is
Auto
or auto-MDIX and
auto-negotiation.
Duplex Limit Select the appropriate duplex setting:
Full
or
Half
. The default
is Full duplex.
Enable Alarms
(Check/Uncheck) Check the checkbox to enable the alarm feature. Uncheck the
checkbox to disable the alarm feature. The default is
Disabled .
SFP1 and SFP2 Enable Check the checkbox to enable the port or uncheck it to disable
the port. The default is
Enabled
.
Note:
The rate limit for the SFP ports is set to 1 Gb and cannot
be modified.
Enable Alarms Check the checkbox to enable the alarm feature. Uncheck the
checkbox to disable the alarm feature. The default is
Disabled .
BP1 to BP4
(backplane connections) Selectable Use the drop-down boxes to select a backplane connection for
Channels A to D. This step sets up a connection between the
selected backplane connection and the rear panel connections.
The connection options that display varies depending on the
module types that the host chassis contains.