Page 2
9. Install the plastic support arm. First
remove the adhesive backing on the
back of the plastic arm.
10. The plastic tubing comes pre-
attached to the plastic arm with two ad-
hesive bands. Position the plastic arm
on the far upper right side of the printer.
Tips:
•
Perform a nozzle check from the Epson driver utility — A few cleanings
may be necessary to prime the system.
•
You may have a little air in your lines but this will clear after a few prints.
•
If you are going to leave your system without using it for several days you
should turn the plastic valves on the ink bags to the shut/off position.
•
Do not raise the ink box higher than the printer.
•
Read the documentation on Configuring your Epson Stylus C120 Printer
Driver for ArTainium ICC Profiles to assist with printing.
7. Place the ink dampers into the empty
ink bay cartridge. The Black ink damper
should be on the far left side, the yellow
on the far right side.
11. The plastic arm should be aligned so
that the edge of the adhesive Velcro is
situated at the upper top right hand cor-
ner of the ink cartridge bay. Press the
plastic arm firmly to set the adhesive
Velcro in place.
8. Firmly push down the plastic
Cartridge set of dampers to completely
engage the ink dampers into place.
Note: You will have to push each individ-
ual damper hinge into position until it
clicks into place (see arrow). The printer
will not ‘recognize’ the ink damper until it
is firmly pushed into place.
C120 Bulk Ink System Installation Instructions
12. Press printer ink button ( second
button on the left side of the printer).
The printer will start to prime and reset
itself. The ink cartridge carriage will
move in position.
13. Congratulations. You have installed
your C120 Easy Flow bulk ink system.
You are now ready to install the ArTain-
ium ICC profiles.
►
◄
