Art-Tech F-14 "TOMCAT" JET, Инструкция по эксплуатации

Страница: 13 / 16

WWW.ART-TECH.COM
12
7 .
Put the elevator trim switch in the middle position, then
make sure the middle line of the elevator corresponds to
the mark on the side of the fuselage and operates correctly.
8 .
Hold the fuselage tightly, move the throttle joystick slowly,
make sure the duct fan work properly.
9.
Your model should now be ready to fly. Have fun !
The reticle on the side of the fuselage.
Tips for flying
1. Make sure that your flight battery and transmitter are at full charge other wise this will effect your
flight performance.
2. Check if the ducted fan running properly, if not, please don't take off.
3. Check if all the servo control surface and front landing gear turn correctly, if not then adjust the servo
reveres switches where necessary.
4. For take of and landing it is important to have the wings at maximum span and also to take of and land
into wind, never try to land down wind.
5. Only take of from a smooth runway, this can be ash felt or grass but is must be smooth and free from
debris.
6. The effect of the aileron is less in the swept back wing position so be aware of this, other radio systems
can allow you to use a tailaron mix which gives a fantastic roll rate which can be used by experienced pilots.
7. Make sure to landing the airplane before the battery running down, otherwise there will be a danger
of crash.